I downloaded the PDF manual. Page 4-3 says: "You may click Refresh to update the display or Click Save As. To save the log contents into a file on your PC, click Save As and save the file to a disk drive." Here is the WG302 ver 3.0.4 support page (firmware, but no manual): http://kbserver.netgear.com/support_details.asp?dnldID=874 Here is the WG302 ver 3.0.0 manual download (newest available): http://kbserver.netgear.com/support_details.asp?dnldID=835 ----- Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302 Using Syslog and Activity Log Information The Information contains the activity log link you can use for setting up a syslog server and viewing activity log information. From the main menu of the browser interface, under the Information heading, click the Station List link to view the list, shown below. [IMAGE] Figure 4-2: Syslog and Activity Log information Enable the SysLog option if you have a SysLog server on your LAN. If enabled, you must enter the IP address of your SysLog server and the port number your SysLog server is configured to use. * SysLog Server IP address: The access point will send all the SysLog to the specified IP address if SysLog option is enabled. Default: 0.0.0.0 * Port: The port number configured in the SysLog server on your LAN. Default: 514 The Activity Log Window displays the Access Point system activity. You may click Refresh to update the display or Click Save As. To save the log contents into a file on your PC, click Save As and save the file to a disk drive. Management 4-3 September 2004 ----- ----- Original Message ----- From: Chris Feyen To: Rob Wentworth Sent: Tuesday, February 22, 2005 2:47 PM Subject: Re: [tcwug-list] Netgear WG302 This AP doesn't seem to have the option to turn off logging, or to clean it out. Rob Wentworth <mail at RobWentworth.com> wrote: Some access points have been known to be more reliable if you turn off (or minimize) logging, due to large logs consuming RAM that is needed for stability. Try turning off logging in your WAP for awhile to see if that increased the mean time between required power cycling,,, Alternatively, review and clear the logs daily (or automate this function to download and clear the logs several times per day). ----- Original Message ----- From: Chris Feyen To: tcwug-list at tcwug.org Sent: Tuesday, February 22, 2005 12:39 PM Subject: [tcwug-list] Netgear WG302 I have a new Netgear WG302 but it doesn't hold a connection to it over a couple of days of activity. I find that it works best when I power cycle it every morning. In hopes of getting this access point reliable, I have updgraded the firmware to 3.0.4 (Nov 15 2004) . Does anyone else have the same access point and found it to be reliable? Or at least found a fix for it? Thanks. _______________________________________________ Twin Cities Wireless Users Group Mailing List - Minneapolis/St. Paul, Minnesota tcwug-list at tcwug.org http://mailman.tcwug.org/mailman/listinfo/tcwug-list